 |
 |
- Simulated blocks like dead time, integrator, time constant, error
detector and gain.
- Square & Triangle source of 1V p-p (min) at 40Hz.
- On-board PID set value constants using potentiometer.
- Built-in 3 1/2 digit DVM for DC measurements.
View DataSheet
|
 |
 |
 |
- Simulated first, second and third order system of type-0 and type-1
- Calibrated variable gain amplifier (Resolution 1:1000)
- Square & Triangle source of 45-90Hz
- Uncommitted amplifier for phase adjustment.
- Provision for disturbance inputs.
View DataSheet
|
|
|
 |
 |
- High quality servo-potentiometers of 360° shaft rotation.
- Built-in signal and power sources.
- 3 1/2 digits DVM for measurements.
View DataSheet
|
|
|
 |
 |
- Synchro transmitter-receiver pair with calibrated dials
- Locking system for receiver rotor
- Receiver use as control transformer
- Built-in balanced demodulator circuit
- Panel meter for ac/dc voltages.
View DataSheet
|
|
|
 |
 |
- Temperature controller with facilities for P. I, D and relay control
blocks.
- Operating temperature: Ambient to 90° C.
- Separate controls for P, I, D channel gains.
- Fast 25W oven fitted with IC temperature sensor.
- Digital display of set and measured temperature on 3 1/2 digit built-in
DVM.
View DataSheet
|
|
|
 |
 |
- Study of 4 different temperature transducers - NTC thermistors, RTD
Platinum, K(Cr-Al) thermocouples, IC temperature sensors.
- Study & comparison of Temperature transducer controlled alarm system
- Instrumentation amplifier, add on amplifier : X1, X100, X235
- Digital meter: Actual/Set temp/mv
View DataSheet
|
|
|
|
 |
- Square & Sine source of Frequency: 10, 20, 40, 80, 100, 200, 400,
800 and 1000Hz
- Simulated 2nd order linear plant. Facility for displaying x and x
signaling.
- Dead zone variable from 0-600mV.
- Hysteresis variable from 0-500m
View DataSheet
|
|
|
|
 |
- Speed control of a 12V, 4W permanent magnet d.c. motor.
- Speed range: 0 to 3000 rpm (typical)
- Opto-interrupter based speed sensing.
- Electronic tachogenerator for feedback.
- 4-digit speed display in rpm & 3 1/2 digit DVM for signal measurements.
View DataSheet
|
|
|
|
 |
- Square & Sine source of 25Hz to 800Hz
- Simulated 'uncompensated' system having adjustable damping.
- Built-in variable gain amplifier & is adjustable from 1 to 11.
View DataSheet
|
|
|
|
 |
- Signal stepping and free running modes of operating with speed variation
and direction reversal using internal TTL circuit.
- 360° motion Servo-Potentiometer position-pickup for motor dynamics.
- Operation through microprocessor kit-sample control programs provided.
- Stepper motor of Torque 3 Kg-cm with Step angle of 1.8°.
View DataSheet
|
|
|
|
 |
- Built-in D/A and A/D circuit (8-bit)
- 8085 based uP-kit as digital controller with user software in 8K
EPROM.
- 16-bit arithmetic for algorithm calculations.
- 16 built-in levels of p. I and D gain each.
View DataSheet
|
|
|
|
 |
- 2-phase a.c. servomotor - 12V/50Hz per phase.
- Small generator for loading.
- 4-digit speed display, 3-digit time constant display.
- 3 1/2 digit r.m.s. voltmeter & d.c. panel meter.
View DataSheet
|
|
|
|
 |
- Position control of a 12V, 1A d.c. gear motor (50rpm)
- Provision for positive and negative tachogenerator feedback.
- Tacho constant: 2V/ 1000 rpm approximately.
- Calibrated dials for reference and output position: resolution 1°.
- UP based waveform capture card.
View DataSheet
|
|
|
|
 |
- 2-phase servomotor 12V/ phase, 50Hz, 10W.
- Power amplifier.
- Servo potentiometer type error detector.
- In-built 10.00V (rms) panel meter.
- uP based waveform capture card.
View DataSheet
|
|
|
|
 |
- Light Sensor
- Built-in 31/2 digital DVM.
- Seven lamps 6V/300mA.
- 5Hz square and triangular wave for dynamic response study.
View DataSheet
|
|
|
|
 |
- Two saturable reactors in one frame
- 2 Rectifiers
- Fixed Resistive load
- DC bias voltage,One potentiometer
- Two digital meters
View DataSheet
|
